Next I took the original plastic jaw and reshaped it so it would fit around the gear teeth.
Next I will fabricate the top of the skull, and figure out how best to punkify this skull so that it looks more mechanical.
|
|---|
|
|---|
Tuesday, August 11, 2009
Skull Respirator: First Casting
Once the silicone rubber mold was cured I cast the skull in a gray urethane resin.
Next I took the original plastic jaw and reshaped it so it would fit around the gear teeth.
Next I will fabricate the top of the skull, and figure out how best to punkify this skull so that it looks more mechanical.
Next I took the original plastic jaw and reshaped it so it would fit around the gear teeth.
Next I will fabricate the top of the skull, and figure out how best to punkify this skull so that it looks more mechanical.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment